KTI Networks KCD-3PB Guide d'installation télécharger pdf (Page 28)

-28-

3.1.3 FX Duplex Setting SW7

This setting is used to set the duplex mode of the FX port. It is recom-

mended to use full duplex mode for FX connection unless its link partner

is a fixed half duplex device. Half duplex mode will shorten the connec-

tion distance. The following table lists the maximum MMF cable length

connecting to different devices:

Link Partner of FX Port Distance (MMF cable)

Network card half-duplex fiber port 400 m

Network card full-duplex fiber port 2 km

Class I hub half-duplex fiber port 160 m

2 Class II hub half-duplex fiber port 112 m

Switched half-duplex fiber port 400 m

Switched half-duplex fiber port 2 km

Note: For SMF connection, be sure the link partner is a full duplex

device and set SW7 to full duplex mode for the FX port.

3.1.4 Factory Default Settings

The factory default settings are as follows:

SW1 OFF TP port mode - auto-negotiation

SW2 OFF TP port - full duplex

SW3 OFF TP port - 100Mbps

SW4 OFF Enable Link Fault Pass Through function

SW5 OFF Store-and-forward always mode

SW6 OFF Enable IEEE 802.3x flow control function

SW7 OFF FX port - full duplex

SW8 OFF Reserved

1 2 ... 23 24 25 26 27 28 29

Pas de commentaire

KTI Networks KCD-3PB Guide d'installation Page 28