KTI Networks Switch 10/100/1000 Base-T Guide d'installation télécharger pdf (Page 29)

-29-

3.2.9 Bandwidth Management

Bandwidth Management function is used to set up the limit of Ingress and Egress bandwidth for each

port.

Note:

Each port of the switch owns 16KB packet buffer. The packet buffer size will be reduced when

the bandwidth rate limitation is enabled, which may cause that jumbo frame cannot be forwarded.

Avoid enabling jumbo frame and bandwidth rating functions at the same time.

Ingress Rate Limiting parameter description:

Port Number: Choose the port that you would like this function to work on it. Valid range

of the port is 1~24. Multiple port selection is allowed. [All] means all ports

(Port 1 ~ 24).

All Traffic: Set up the limit of Ingress bandwidth for the selected ports. Incoming

traffic will be discarded if the rate exceeds the value you set up in Data

Rate field. Pause frames are also generated if flow control is enabled. The

format of the packet limits to Unicast, broadcast and multicast.

Data Rate (Mbps): Valid range is 0~1000.

Broadcast & Multicasat: Set up the limit of Ingress bandwidth for the port you choose. Incoming

traffic will be discarded if the rate exceeds the value you set up in Data

Rate field. The format of the packet only limits to broadcast and multicast.

Data Rate (Mbps): Valid range is 0~1000.

Egress Rate Limiting parameter description:

All Traffic: Set up the limit of Egress bandwidth for the port you choose. Packet

transmission will be delayed if the rate exceeds the value you set up in

Data Rate field. Traffic may be lost if egress buffers run full. The format

of the packet limits to Unicast, broadcast and multicast.

Data Rate (Mbps): Valid range is 0~1000.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Pas de commentaire

KTI Networks Switch 10/100/1000 Base-T Guide d'installation Page 29