Kti-networks Web Smart Managed 10/100 Fast Ethernet Switches wi Manuel d'utilisateur télécharger pdf (Page 10)

-10-

2. Installing the Switches

2.1 Unpacking

Check to see that you have everything before you start the installation.

• Installation guide

• The switch unit

• Rubber magnet stand

• One AC power adapter for the unit

2.2 Supply the Power

Checking AC Power

Before you begin the installation, check the AC voltage of your area. The

AC power adapter which is used to supply the DC power for the unit should

have the AC voltage matching the commercial power voltage in your area.

The specifications of the AC power adapter are:

• AC input power: AC power voltage of your area

• DC output power: Rating +7.5V VDC min. 1.0A

• DC plug type:

DC IN Jack

The DC power jack for the AC power adapter is located on the rear of the

switch. Refer to section 1.2 drawing.

Installing the Switch

1. Install the switch with the AC power adapter provided.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Pas de commentaire

Kti-networks Web Smart Managed 10/100 Fast Ethernet Switches wi Manuel d'utilisateur Page 10