Kti-networks Web Smart Managed 10/100 Fast Ethernet Switches wi Manuel d'utilisateur télécharger pdf (Page 22)

-22-

3.2 Port Setup

The middle part of previous figure shows all port status of the connected

switch. The right side shows port configuration setup page.

Port Status

Port Status page displays the current port status. The status are:

Port Port number (FX : FX port)

Link Port link status, Up = link up, Down = link down

Speed Port speed, 100M = 100Mbps, 10M = 10Mbps

Duplex Duplex mode used, Full = full-duplex, Half = half-duplex

Flow Control Flow control status, enabled, disabled

Note:

The switch is featured with flow control enabled for all ports. However,

the flow control may be disabled after auto negotiation with the con-

nected device, if the connected device does not have flow control ability.

Port Setup

This page is used to set the port configuration for each port. As auto-

negotiation function is enabled, speed and duplex settings specify the

highest port ability for negotiation process between the switch and the

auto-negotiation capable link partner. When auto-negotiation function

is disabled, speed and duplex settings specify the forced port configura-

tion for the connection. Setup options are:

Auto-negotiation Enabled, disabled

Speed 100M = 100Mbps, 10M = 10Mbps

Duplex Full = full-duplex, Half = half-duplex

It is recommended to set auto-negotiation enabled in most of cases and

set it disabled only when connecting to an auto-negotiation incapable

full-duplex device.

[Apply] Click to make the setup effective immediately

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Pas de commentaire

Kti-networks Web Smart Managed 10/100 Fast Ethernet Switches wi Manuel d'utilisateur Page 22